Edit File: ipmisim1.emu
# This is an example simulation setup for ipmi_sim. It creates a single # management controller as a BMC. That will have the standard watchdog # sensor and we add a temperature sensor. # The BMC is the MC at address 20 mc_setbmc 0x20 # Now add the BMC mc_add 0x20 0 no-device-sdrs 0x23 9 8 0x9f 0x1291 0xf02 persist_sdr sel_enable 0x20 1000 0x0a # Watchdog sensor. This must be sensor zero. sensor_add 0x20 0 0 35 0x6f event-only sensor_set_event_support 0x20 0 0 enable scanning per-state \ 000000000001111 000000000000000 \ 000000000001111 000000000000000 # Add a temperature sensor and its SDR. Note that sensor 0 is already # taken as the watchdog sensor. sensor_add 0x20 0 1 0x01 0x01 # Start with the value set to 0x60 sensor_set_value 0x20 0 1 0x60 0 # Set just the upper thresholds with the values 0x70, 0x90, and 0xa0 sensor_set_threshold 0x20 0 1 settable 111000 0xa0 0x90 0x70 00 00 00 # Enable all upper threshold events events sensor_set_event_support 0x20 0 1 enable scanning per-state \ 000111111000000 000111111000000 \ 000111111000000 000111111000000 # Add a memory module presence sensor. sensor_add 0x20 0 2 37 0x6f sensor_set_bit_clr_rest 0x20 0 2 1 1 #sensor_set_bit_clr_rest 0x20 0 2 0 1 sensor_set_event_support 0x20 0 2 enable scanning per-state \ 000000000000011 000000000000011 \ 000000000000011 000000000000011 # FRU data for entity 8.2 mc_add_fru_data 0x30 3 128 data 0 # Add a satellite MC mc_add 0x30 2 no-device-sdrs 0x98 0x10 1 0xa0 0x1291 0xf03 sensor_add 0x30 0 1 0x01 0x01 # Uncomment the following and comment the proceding to read the value # from the given file. You can modify the file contents. #sensor_add 0x30 0 1 0x01 0x01 poll 1000 file "/tmp/file1.ipm" sensor_set_threshold 0x30 0 1 settable 111000 0xa0 0x90 0x70 00 00 00 sensor_set_event_support 0x30 0 1 enable scanning per-state \ 000111111000000 000111111000000 \ 000111111000000 000111111000000 mc_enable 0x30 # Turn on the BMC mc_enable 0x20