Edit File: Kconfig_mrmt
# RMT for NGW100 customization choice prompt "RMT Version" help Select the RMTx board version. config BOARD_MRMT_REV1 bool "RMT1" config BOARD_MRMT_REV2 bool "RMT2" endchoice config BOARD_MRMT_AC97 bool "Enable AC97 CODEC" help Enable the UCB1400 AC97 CODEC driver. choice prompt "Touchscreen Driver" default BOARD_MRMT_ADS7846_TS config BOARD_MRMT_UCB1400_TS bool "Use UCB1400 Touchscreen" config BOARD_MRMT_ADS7846_TS bool "Use ADS7846 Touchscreen" endchoice choice prompt "RMTx LCD Selection" default BOARD_MRMT_LCD_DISABLE config BOARD_MRMT_LCD_DISABLE bool "LCD Disabled" config BOARD_MRMT_LCD_LQ043T3DX0X bool "Sharp LQ043T3DX0x or compatible" help If using RMT2, be sure to load the resistor pack selectors accordingly if BOARD_MRMT_REV2 config BOARD_MRMT_LCD_KWH043GM08 bool "Formike KWH043GM08 or compatible" help Be sure to load the RMT2 resistor pack selectors accordingly endif endchoice if !BOARD_MRMT_LCD_DISABLE config BOARD_MRMT_BL_PWM bool "Use PWM control for LCD Backlight" help Use PWM driver for controlling LCD Backlight. Otherwise, LCD Backlight is always on. endif config BOARD_MRMT_RTC_I2C bool "Use External RTC on I2C Bus" help RMT1 has an optional RTC device on the I2C bus. It is a SII S35390A. Be sure to select the matching RTC driver. choice prompt "Wireless Module on ttyS2" default BOARD_MRMT_WIRELESS_ZB config BOARD_MRMT_WIRELESS_ZB bool "Use ZigBee/802.15.4 Module" config BOARD_MRMT_WIRELESS_BT bool "Use Bluetooth (HCI) Module" config BOARD_MRMT_WIRELESS_NONE bool "Not Installed" endchoice