^^&&^^

Edit File: snmp.acl.template

# ----------------------------------------------------------------------
#           Template for SNMP Access Control List File
#
# o Copy this template to snmp.acl
# o Set access control for SNMP support
# o Change the permission of snmp.acl to be read-only
#   by the owner.
#
# See below for the location of snmp.acl file.
# ----------------------------------------------------------------------

############################################################
#            SNMP Access Control List File  
############################################################
#
# Default location of this file is $JRE/lib/management/snmp.acl.
# You can specify an alternate location by specifying a property in 
# the management config file $JRE/lib/management/management.properties
# or by specifying a system property (See that file for details).
#

##############################################################
#        File permissions of the snmp.acl file
##############################################################
# 
#      Since there are cleartext community strings stored in this file,
#      this ACL file must be readable by ONLY the owner,
#      otherwise the program will exit with an error. 
#
##############################################################
#		Format of the acl group
##############################################################
#
# communities: a list of SNMP community strings to which the
#              access control applies separated by commas.
#
# access: either "read-only" or "read-write".
#
# managers: a list of hosts to be granted the access rights.
#    Each can be expressed as any one of the following:
#    - hostname: hubble
#    - ip v4 and v6 addresses: 123.456.789.12 , fe80::a00:20ff:fe9b:ea82
#    - ip v4 and v6 netmask prefix notation: 123.456.789.0/24, 
#         fe80::a00:20ff:fe9b:ea82/64  
#      see RFC 2373 (http://www.ietf.org/rfc/rfc2373.txt)
#
# An example of two community groups for multiple hosts:
#    acl = {
#     {
#       communities = public, private
#       access = read-only
#       managers = hubble, snowbell, nanak
#     }
#     {
#       communities = jerry
#       access = read-write
#       managers = hubble, telescope
#     }
#    }
# 
##############################################################
#                   Format of the trap group
##############################################################
#
# trap-community: a single SNMP community string that will be included
#                 in  the traps sent to the hosts.
#
# hosts: a list of hosts to which the SNMP agent will send traps.
#
# An example of two trap community definitions for multiple hosts:
#    trap = {
#      {
#        trap-community = public
#        hosts = hubble, snowbell
#      }
#      {
#        trap-community = private
#        hosts = telescope
#      }
#    }
#
############################################################
#
#  Update the community strings (public and private) below
#  before copying this template file
# 	
# Common SNMP ACL Example
# ------------------------
#
# o Only localhost can connect, and access rights
#   are limited to read-only
# o Traps are sent to localhost only
#
#
# acl = {
#  {
#    communities = public, private
#    access = read-only
#    managers = localhost
#  }
# }
# 
# 
# trap = {
#   {
#     trap-community = public
#     hosts = localhost 
#   }
# }