Edit File: README.decnet
Here are a few quick points about DECnet support... o iproute2 is the tool of choice for configuring the DECnet support for Linux. For many features, it is the only tool which can be used to configure them. o No name resolution is available as yet, all addresses must be entered numerically. o Remember to set the hardware address of the interface using: ip link set ethX address xx:xx:xx:xx:xx:xx (where xx:xx:xx:xx:xx:xx is the MAC address for your DECnet node address) if your Ethernet card won't listen to more than one unicast mac address at once. If the Linux DECnet stack doesn't talk to any other DECnet nodes, then check this with tcpdump and if its a problem, change the mac address (but do this _before_ starting any other network protocol on the interface) o Whilst you can use ip addr add to add more than one DECnet address to an interface, don't expect addresses which are not the same as the kernels node address to work properly with 2.4 kernels. This should be fine with 2.6 kernels as the routing code has been extensively modified and improved. o The DECnet support is currently self contained. It does not depend on the libdnet library. Steve Whitehouse <steve@chygwyn.com>